Build Hydrogen Generator By Your Own
August 22nd, 2010 | 
Author: Build Hydrogen Generator By Your Own
If you wish to reduce your expenses and simultaneously help the environmentalists then a hydrogen generator would turn out to be the best alternative. It is a cleaner substitute for petroleum which will revolutionize the entire automobile industry across the world and the put an end to the anxiety over the rising petrol prices. Not only does it produce water on combustion which means absolutely no pollution at all but also enhances the gas mileage. A hydrogen generator is already in use in laboratories whenever high purity hydrogen is required. The hydrogen generated from this of 99.99 purity. They are small in size and weight generally occupying 12 square feet of bench and weighing 3060 lbs. Few hydrogen generators require the addition of caustic solution to produce hydrogen gas but most others require only deionized or distilled water. Generators that use only water are more desirable as they reduce the risks of handling more chemical substances.
Home made hydrogen generators do not require much effort amp; the procedure for it is given below. Things needed: Scissors Bottles Knife Carpenter pencil Telephone wire hot glue glue gun tubing and electrodes Valve
Step1: Cut the top off a 2 liter plastic bottle and the bottoms off of two 20 ounce plastic bottles using a pair of scissors. Cut the larger bottle enough so that the two smaller bottles fit comfortably inside of it. Be sure to retain the screw on caps form the bottles.
Step2: Use a sharp utility knife to carefully cut away the wooden casing of the pencil leaving you with just the carbon graphite lead shaft. Break the lead into two separate but equal pieces using your knife.
Step3: Remove the approximately frac14; inch of insulation from two 12 inch telephone wires using a stripping pliers before removing 2 more inches of insulation from the opposite ends.
Step4: Wrap the exposed copper from the telephone wire at the 2 inch end around the ends of the pencil lead and secure in place with a little hot glue.
Step5: Use a drill to drill holes into the center of the two small pop bottle caps and attach a 24inch long piece of plastic aquarium tubing. Secure in place by placing a little hot glue around both the inside and outside hole perimeter. Once dry replace the caps onto the bottles by screwing into place.
Step6: Place electrodes with wire attached in the bottom side of the two small pop bottles using hot glue to secure it in place. Put the small bottles inside the large pop bottle and hot glue in place so they cannot move.
Step7: Place an aquarium 2 to 1 mixer value into the free ends of the tubing before connecting to the wires from the electrodes to the correct terminals on a 12volt battery. It may be an idea to label the positive wire Anode Oxygen and the negative wire Cathode Hydrogen.
Materializing the above model in automobiles helps us in dealing with major global issues like Global warming.
nbsp;
About the writer: To find out more about using water to run your car and get a free question and answer report please visit www.RunCarOnWater.com
Related posts:
Posted in cars
